Skip to content
naulon

Not checkedNot checked for notices yet.

A 3D Finite Element Analysis on Stress Distribution of Two Ceramic Materials Used for Fabrication of Laminate Veneers using Two Preparation Designs: An In-vitro Study

Supriyo Jana, Jayanta Bhattacharyya, Samiran Das and 5 more

Journal of Clinical and Diagnostic Research · 2025

doi:10.7860/jcdr/2025/74115.21232 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Introduction: Veneers have been successfully used in cases of aesthetic and cosmetic dentistry. As the thickness of veneers needs to be 0.5 mm to enable bonding to enamel, the preparation of teeth is crucial to ensure longevity. There are numerous incisal preparation designs for veneers, but there is no uniform opinion among various investigators regarding the preferred design parameters. Knowledge of the intensity and distribution of stresses may aid in predicting the failure patterns of veneers with different types of preparations. Aim: To evaluate the maximum principal stresses generated on the model of a maxillary central incisor tooth designed to be restored with veneers made from two different materials: Lithium disilicate and Zirconia, and prepared according to two distinct incisal designs: with “incisal butt-joint” and with “incisal palatal mini-chamfer”. Materials and Methods: This was an in-vitro study conducted at Guru Nanak Institute of Dental Science and Research, Kolkata, India between March 2018 and June 2019. A three-dimensional (3D) Finite Element Analysis (FEA) was employed to evaluate the maximum principal stresses. A virtual 3D model of an extracted maxillary central incisor tooth was obtained using Digital Imaging and Communications in Medicine (DICOM) images from a micro Computer Tomography (CT) scan and assembled using Materialise Interactive Medical Image Control System (MIMICS) software. One model was created for each of the four variable designs and materials. The 3D objects corresponding to the “veneer,” “underlying cement layer,” and “remaining tooth structure” were meshed in the Materialise 3-matic (3-MATIC) software. A single static load consistent with incisal bite force in natural dentition was applied to the tooth in the incisal third on the palatal surface at a 135º angle. The pattern of stresses in the model was calculated in numerical values and depicted in colour coding. The maximum principal stress values were calculated separately for the “veneers,” “underlying cement layer,” and “remaining tooth structure,” and were tabulated. The mean and p-values were calculated. Results: The butt-joint preparation showed less maximum stress on the “veneers” {p-value 0.51 (F1) and 0.01 (F2)}, “cement layer” {p-value 0.0007 (F1) and 0.0004 (F2)}, and “remaining tooth structure” {p-value 0.40 (F1) and 0.47 (F2)} compared to the palatal chamfer preparation. The zirconia-restored veneers with butt-joint preparation {p-value 0.12 (F1) and 0.05 (F2)} and palatal mini-chamfer preparation {p-value 0.05 (F1) and 0.80 (F2)} imparted less stress than the lithium disilicate restored veneers. Conclusion: Butt-joint preparation of the veneers proved to be better than the palatal chamfer, and zirconia proved to be a better restorative material than lithium disilicate for veneers.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.