Skip to content
naulon
Not checkedNot checked for notices yet.

Surface Features of Nanocrystalline Alloys

Marcel Miglierini, Peter Matúš

Croatica Chemica Acta · 2015

doi:10.5562/cca2757 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Nanocrystalline alloys are prepared by controlled annealing of metallic glass precursors. The latter are obtained by rapid quenching of a melt on a rotating wheel. This process leads to structural deviation of the produced ribbons’ surfaces. Structural features of as-quenched and thermally annealed <sup>57</sup>Fe<sub>81</sub>Mo<sub>8</sub>Cu<sub>1</sub>B<sub>10</sub> ribbons were studied employing Conversion Electron Mössbauer Spectrometry (CEMS) and Conversion X-ray Mössbauer Spectrometry (CXMS). Enrichment of the alloy’s composition in <sup>57</sup>Fe helped in identification of surface crystallites that were formed even during the production process. Magnetite and bcc-Fe were found at the wheel side of the as-quenched ribbons whereas only bcc-Fe nanocrystals were uncovered at the opposite air side. Accelerated formation of bcc-Fe was observed in this side of the ribbons after annealing. The relative content of magnetite at the wheel side was almost stable in near surface areas (CEMS) and in more deep subsurface regions (CXMS). It vanished completely after annealing at 550 °C. No magnetite was observed at the air side of the ribbons regardless the annealing temperature and/or depth of the scanned regions.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.