The effect of sediment thermal conductivity on vertical groundwater flux estimates

<p>Vertical sediment temperature profiles are frequently used to estimate vertical fluid fluxes. In these applications using heat as a tracer of groundwater flow, the thermal conductivity of saturated sediments (<span class="inline-formula"><i>k</i>_<i>e</i>)</span> is often given as a standard literature value and assumed to have a homogeneous distribution in the vertical space. In this study vertical sediment temperature profiles were collected in both a high-flux stream and a low-flux lagoon environment in sand- and peat-covered areas. <span class="inline-formula"><i>k</i>_<i>e</i></span> was measured at the location of each temperature profile at several depths below the sediment–water interface up to 0.5&thinsp;m with a measurement spacing of 0.1&thinsp;m. In general <span class="inline-formula"><i>k</i>_<i>e</i></span> values measured in this study ranged between 0.55 and 2.96&thinsp;W&thinsp;m<span class="inline-formula">⁻¹</span>&thinsp;<span class="inline-formula">^∘</span>C<span class="inline-formula">⁻¹</span> with an increase with depth from the sediment–water interface. The effect of using a vertically homogeneous or heterogeneous distribution of measured <span class="inline-formula"><i>k</i>_<i>e</i></span> values on vertical flux estimates was studied with a steady-state HydroGeoSphere model. In the high-flux stream environment estimated fluxes varied between 0.03 and 0.71&thinsp;m&thinsp;d<span class="inline-formula">⁻¹</span> and in the low-flux lagoon between 0.02 and 0.23&thinsp;m&thinsp;d<span class="inline-formula">⁻¹</span>. We found that using a vertically heterogeneous distribution of sediment thermal conductivity did not considerably change the fit between observed and simulated temperature data compared to a homogeneous distribution of <span class="inline-formula"><i>k</i>_<i>e</i></span>. However, depending on the choice of sediment thermal conductivities, flux estimates decreased by up to 64&thinsp;% or increased by up to 75&thinsp;% compared to using a standard <span class="inline-formula"><i>k</i>_<i>e</i></span> sediment thermal conductivity for sand, frequently assumed by previous local studies. Hence, our study emphasizes the importance of using spatially distributed thermal properties in heat flux applications in order to obtain more precise flux estimates.</p>

Abstract licence: CC BY

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.