Skip to content
naulon

Not checkedNot checked for notices yet.

A large-area blackbody for in-flight calibration of an infrared interferometer deployed on board a long-duration balloon for stratospheric research

F. Olschewski, C. Monte, A. Adibekyan and 4 more

Atmospheric Measurement Techniques · 2018

doi:10.5194/amt-11-4757-2018 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

<p>The deployment of the imaging Fourier Transform Spectrometer GLORIA (Gimballed Limb Observer for Radiance Imaging of the Atmosphere) on board a long-duration balloon for stratospheric research requires a blackbody for in-flight calibration in order to provide traceability to the International Temperature Scale (ITS-90) to ensure comparability with the results of other experiments and over time. GLORIA, which has been deployed onboard various research aircraft such as the Russian M55 Geophysica or the German HALO in the past, shall also be used for detailed atmospheric measurements in the stratosphere up to 40&thinsp;km altitude. The instrument uses a two-dimensional detector array and an imaging optics with a large aperture diameter of 36&thinsp;mm and an opening angle of 4.07°&thinsp; × &thinsp;4.07° for infrared limb observations. To overfill the field of view (FOV) of the instrument, a large-area blackbody radiation sources (125&thinsp;mm&thinsp; × &thinsp;125&thinsp;mm) is required for in-flight calibration.</p><p>In order to meet the requirements regarding the scientific goals of the GLORIA missions, the radiance temperature of the blackbody calibration source has to be determined to better than 100&thinsp;mK and the spatial temperature uniformity shall be better than 150&thinsp;mK. As electrical resources on board a stratospheric balloon are very limited, the latent heat of the phase change of a eutectic material is utilized for temperature stabilization of the calibration source, such that the blackbody has a constant temperature of about −32&thinsp;°C corresponding to a typical temperature observed in the stratosphere.</p><p>The Institute for Atmospheric and Environmental Research at the University of Wuppertal designed and manufactured a prototype of the large-area blackbody for in-flight calibration of an infrared interferometer deployed on board a long-duration balloon for stratospheric research. This newly developed calibration source was tested under lab conditions as well as in a climatic and environmental test chamber in order to verify its performance especially under flight conditions. At the PTB (Physikalisch-Technische Bundesanstalt), the German national metrology institute, the spatial radiance distribution of the blackbody was determined and traceability to the International Temperature Scale (ITS-90) has been assured. In this paper the design and performance of the balloon-borne blackbody (BBB) is presented.</p>

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.