Skip to content
naulon

Not checkedNot checked for notices yet.

Development of Calculation Method for Tensile Strength of Rock Samples under Compression

Leonid M. Vasil’ev, Michael A. Zhuravkov, Dmitriy L. Vasil’ev and 2 more

Механика машин, механизмов и материалов · 2020

doi:10.46864/1995-0470-2020-4-53-85-91 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The paper describes a procedure for improving the approach to determining the ultimate strength of rock samples, the basic method is L. Prandtl’s method. In earlier works of the authors of this paper, the L. Prandtl’s method was improved in relation to rocks, using a general algebraic equation for calculating horizontal normal stresses depending on the vertical component and mechanical characteristics of the rock. Here, the authors reject the assumption that the tangent contact stresses resulting from L. Prandtl's solution do not depend on the abscissa x and on the variable vertical stresses, in contrast to the well-known Coulomb–Amonton law, according to which the tangent stresses are directly proportional to the vertical pressure. The regularities of contact normal and tangential stresses distribution at failure of prismatic samples are clarified. As result, the method was developed for calculating the tensile strength of samples with three characteristic values of mechanical properties: kп, yield strength of material in shear; ρ, angle of internal friction; fс, coefficient of contact friction. These characteristics can be established experimentally by simple experimental studies. The proposed approach is effective for constructing ultimate curves and diagrams of “stress — longitudinal strain” of rocks in the case of contact friction. A comparative evaluation is given for the proposed method for calculating the tensile strength of samples during their destruction with experimental data. Comparison of the calculated tensile strength with experimental data shows that the relative error of calculations according to the proposed method is significantly lower than the relative error of calculations performed using the E. Unksov’s method. The proposed method can be recommended for practical application.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.