Modelling and Microstructural Aspects of Ultra-Thin Sheet Metal Bundle Cutting

The results of numerical simulations of the cutting process obtained by means of the finite element method were studied in this work. The physical model of a bundle consisting of ultra-thin metal sheets was elaborated and then submitted to numerical calculations using the computer system LS-DYNA. Experimental investigations rely on observation of metallographic specimens of the surfaces being cut under a scanning electron microscope. The experimental data showing the microstructure of an ultra-thin metal bundle were the basis for the verification of the numerical results. It was found that the fracture area consists of two distinct zones. Morphological features of the brittle and ductile zones were identified. There are distinct differences between the front and back sides of the knife. The experimental investigations are in good agreement with the simulation results.

Abstract licence: CC BY

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.