Skip to content
naulon
Not checkedNot checked for notices yet.

The Improvement of The Solar Air Heater Duct by Wired Ribs Utilization

Osamah Raad skheel/alkhafaji

Karbala International Journal of Modern Science · 2019

doi:10.33640/2405-609x.1163 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Abstract Heat transfer coefficient of the solar air heater duct (SAH) is low due increasing the thermal performance of its absorber. The present study tends to enhance the thermal characteristics of the SAH by adopting the wired ribs on the absorber under different ribs dimensions and arrangements. A rectangular duct is used to form the SAH with length L=1500mm, width w=100mm and height H=30mm. The used heat fluxes over the absorber are 1000W/m2 and 500W/m2 while the operated Reynolds number range is 708 ~ 6375. The utilized wired ribs are arranged over the absorber so as to develop a relative roughness height value (e/D = 0.043) in which generates a relative roughness pitch values of (P/e = 5, 10, 15). Moreover, another arrangement for the wired ribs develops a relative roughness height value (e/D = 0.086) that correspond the relative roughness pitch values of (P/e = 10, 20, 30). The results show an improvement in the average values of the Nusselt number with 9.34 % when e/D = 0.043 and heat flux of 500W/m 2 against the smooth absorber. It is also found that the average values of Nusselt number is improved with 5.31% when e/D=0.043 and heat flux = 1000W/m2.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.