Trace Determination of Hydrogen in Coke by Elemental Analysis
Romolo Cicciarelli, Basil Zuber, Christian Ambort
CHIMIA · 2002
doi:10.2533/000942902777680270 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Recarburizers used in the steel industry are ruthlessly selected according to their quality. One of the critical parameters is the residual hydrocarbon content of the coke or graphite-based products. The current analytical procedure has a detection limit of about 0.2% hydrogen. The dynamic flash combustion of the sample coupled with gas chromatography (GC) was used to develop a simple method for the determination of hydrogen traces in coke. The sample was burned in an oxygen/helium atmosphere at 1020 °C. Separation of the combustion gases, NO2, CO2, H2O, and SO2, is accomplished on a chromatography column and measured by a thermal conductivity detector TCD. A linear response of hydrogen over a concentration range of 98–4910 mg kg?1 with a correlation coefficient of 0.9985 has been achieved. A detection limit of 26 mg kg?1 and a determination limit of 92 mg kg?1 were obtained with new equipment configurations and a sample weight of 8 mg. This corresponds to an impressive improvement of sensitivity of a factor of over 70. The coefficient of variation was found to be 31.3% at a concentration of 98 mg kg?1 and 0.7% at 4910 mg kg?1.
Abstract licence: CC BY-NC
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.