3D Printed Pressure Sensor Based on Surface Acoustic Wave Resonator
Hu Baofa, Li Zhiwei, Wan Yuanjie and 3 more
Measurement Science Review · 2021
doi:10.2478/msr-2021-0011 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
This paper reports a 3-dimentional (3D) pressure sensor based on surface acoustic wave (SAW) resonators. The SAW resonators were designed and fabricated on 128°Y-X LiNbO3 substrate using the MEMS technology. The pressure sensing structure was 3D-printed using polyactic acid plastic, and two SAW resonators were integrated in the 3D-printed chamber structure for both temperature and pressure sensing. The SAW-based gas pressure sensors demonstrate a sensitivity of 589 ppm/MPa at the pressure range of 100-600 kPa and temperature of 40 °C.
Abstract licence: CC BY-NC-ND
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.