Activity and stability of RuO2-coated titanium anodes prepared via the alkoxide route

Titanium anodes with an active RuO2 coating of two different thicknesses were prepared from the oxide suspended in ethanol ("ink" method), while the oxide itself was synthesized by the hydrolysis of ruthenium ethoxide in an ethanolic solution (alkoxide route). The morphology of prepared oxide was examined by scanning electron microscopy. The electrochemical properties of the prepared Ti/RuO2 anodes, involving their cyclic voltammetric behavior in H2SO4 and NaCl solutions, activity in the chlorine and oxygen evolution reaction, impedance behavior in H2SO4, and stability during electrolysis in dilute chloride solutions, were investigated. The performances of the anodes are compared to those of a Ti/RuO2 anode prepared by the sol-gel procedure from an oxide sol obtained by the forced hydrolysis of ruthenium chloride in acid solution. The anodes prepared via the alkoxide route showed a higher capacitance and activity for the chlorine evolution reaction than the anode prepared by the inorganic sol-gel procedure. The results of the stability test showed that the utilization of the coating active material is better when the anodes were prepared via the alkoxide route than via the inorganic sol-gel procedure, particularly for anodes with a smaller mass of coating. The different rates of loss of activity indicate a degradation mechanism for the anodes prepared via the alkoxide route in which electrochemical dissolution of RuO2 from the coating surface prevails over the growth of an insulating TiO2 layer in the coating/Ti substrate interphase. The effect of RuO2 dissolution from the coating surface increases with increasing coating mass.

Abstract licence: CC BY

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.