Skip to content
naulon

Not checkedNot checked for notices yet.

Mechanical, morphological and water absorption properties of polyethylene/olive pomace flour bio-composites

Raid Banat, Malek Aljnaid, Manal Al-Rawashdeh

Polyolefins Journal · 2022

doi:10.22063/poj.2021.2903.1184 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Mechanical and physical properties of various weigh percentages (0% - 40%) of olive pomace flour (OPF)-loaded linear low density polyethylene (LLDPE) in the presence of 0%, 5% and 10% coupling agent (C) were formulated and studied. Extrusion and hot press processing techniques were used to fabricate OPF/LLDPE composites. Tensile stress at yield increased by 20% with the increasing of the filler loading up to 20%; and marginally increased in the presence of the C. Whereas, the decline in the tensile strain at yield of the polymer composite improved with the increase in the C content. The modulus increased from 631 MPa for the neat LLDPE to 680, 808 and 700 MPa for the composites filled by 5%, 10% and 20% filler content, respectively. Whereas, a decrease in the given modulus (550 MPa) was observed at 40% filler loading. The modulus has shown a successive improvement upon the addition of the C with values not less than 800 MPa. The impact strength decreased with the increase in filler loading from 119 kJ/m2 for the neat LLDPE to 81, 43, 27 and 16 kJ/m2 for the 5%, 10%, 20% and 40% OPF/LLDPE samples, respectively. On the contrary, 10% C addition improved the impact strength of the composite by two folds in the case of 10 - 40% filler inclusion. The scanning electron microscopy (SEM) illustrations proved the mechanical performance of various bio-composite formulations. Water absorption of the bio-composite increased with the OPF loading, from 0.73% for the neat LLDPE to 2.6% for 40% OPF-filled polymer composite, and decreased upon increasing the C content with an average of 1.4% for all composites. Formulated by mixing cellulosic-based material OPF and LLDPE, the bio-composite demonstrated compatible physical properties and can be used as an already available cellulosic filler for the bio-composite materials.

Abstract licence: CC BY-NC-SA

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.