Skip to content
naulon
Not checkedNot checked for notices yet.

Effect of Impeller Trimming on Centrifugal Pump

Sutardi Sutardi, Ridwan Adliansyah

Rekayasa Mesin · 2022

doi:10.21776/ub.jrm.2021.012.03.16 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Pumps, especially centrifugal pumps, play an important role in engineering application, such as petroleum and petro-chemical industries, agricultural industries, portland cement industries etc. To obtain the best performance of the pumps, one has to operate the pumps at their design conditions. In some circumstances, however, the pumps must operate lower than their design conditions and result in the decrease in their performances. In such cases, it is possible to replace the pump impeller with the smaller impeller diameter or to cut its original impeller to smaller size as necessary. The cut of the impeller, or it is frequently referred to as impeller trimming, in some extence is preferable than replacing with new impeller or even by replacing with new pump with smaller head and capacity. In this study, we examine the effect of the pump impeller trimming to the pump performaces. The study was performed in the Fluid Mechanics Laboratory, Mechanical Engineering Department of ITS, Surabaya. The pump impellers were cut up to approximately 19 percent of its original pump impeller diameter, where the original pump impeller diameter is 129 mm. The pump has the maximum capacity of 100 liters/min and the total head of 31.5 m. The pump is powered by a 300 Watt electrical motor. Parameters to be studied in this research include pump capacity, pump head, pump power, and pump efficiency. The results of this study show that all data are in good agreement with the pump affinity laws. Pump capacity, pump head, and pump power decresase as the pump impeller diameter decreases. The pump efficiency is, however, in some extent, increases as the pump impeller diameter decreases. The maximum increase in pump efficiency is obtained when the ratio between the trimmed impeller to its original pump impeller diameter is approximately 89 percent (i.e. D2/D1 = 0.89), with the increase in pump efficiency of approximately 20 percent.

Abstract licence: CC BY-NC

References12

    12 more references, whose wording the paper’s licence keeps private.

    Reads

    Read by people on this page

    None yet.

    Checked or read by AI through naulon

    None yet.

    A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

    Are you an author?

    Is this your paper?

    Claim it to add your note and be paid when agents cite it. Free.