Not checkedNot checked for notices yet.
The Effect of Rotational Speed, Friction Duration, and Pressure on Tensile Strength of AISI 6061 Welding Joints
Dewi Puspitasari, Poppy Puspitasari, M. Rizka Gita Firmansyah and 1 more
Journal of Mechanical Engineering Science and Technology · 2018
doi:10.17977/um016v2i12018p038 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Electric arc welding with covered electrodes is ideally suited for flat plates. If this technique is employed for welding rigid bodies, the results would be of poor quality. One viable solution to weld rigid bodies is through friction welding. The study aimed to investigate the tensile strength of specimens subjected to friction welding with variations in rotational speed, friction time, and pressure and to examine the microstructure of friction welding joints. This research used the one-shot case study design and involved descriptive analysis. The descriptive analysis described the results of tensile testing and microstructure of welding joints. Results showed that the specimen subjected to a 2850 rpm rotational speed, 60-second friction duration, and 8 MPa pressure had the highest tensile strength of 15.19 Kgf, whereas that rotated at 2850 rpm under 8 MPa pressure for 80 seconds had the lowest tensile strength, i.e. 12.25 Kgf. The photomicrographs showed that the friction welding joints underwent no phase change, but the refinement of Mg2Si particles occurred in the Zpd and Zpl zones. Also, the Zud zone consisted of the same form of Mg2Si particles as the untreated specimen.
Abstract licence: CC BY-SA
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.