Skip to content
naulon

Not checkedNot checked for notices yet.

Construction of tissue engineering nucleus pulposus with decellularized stem cell matrix scaffolds and rabbit synovium-derived stem cells in vitro

ZHU Shuitao, MIN Jing, WANG Qunbo and 2 more

Di-san junyi daxue xuebao · 2019

doi:10.16016/j.1000-5404.201808118 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Objective To evaluate the feasibility of constructing tissue engineering nucleus pulposus in vitro. Methods After synovial-derived stem cells (SDSCs) were isolated from adult New Zealand white rabbit and purified, the cells were seeded into the prefabricated scaffolds of decellularized stem cell matrix (DSCM).So, the experiment included 3 groups, blank group (blank DSCM scaffolds), experimental group (SDSCs-DSCM complex) and control group (normal rabbit nucleus pulpous).Gross observation and scanning electron microscopy (SEM) were performed to observe the morphology and internal structure of materials and adhesion of cells.Hematoxylin and eosin (HE) staining was used to observe the distribution of cells in each group, and immunofluorescence histochemical staining was also used to detect the expression of CollagenⅡ protein and Aggrecan.Meanwhile, their mRNA levels were measured by quantitative real-time polymerase chain reaction (qRT-PCR).Compression loading test was used to detect the compressive properties of each group. Results Gross observation found that the obtained tissue engineering nucleus pulposus was close to normal nucleus pulpous in morphology.SEM showed that the cells were adhered and grew well on the inner surface of the scaffolds.HE staining displayed that the cells in the experimental group presented uniform distribution gradually with the elapse of time.Immunofluorescence histochemical staining and qRT-PCR indicated that the expression of CollagenⅡand Aggrecan at protein and mRNA levels were increased with time, and all above levels were significantly lower than those in the control group (P < 0.05).The results of compression loading test showed that there was no statistical difference in compression load between the experience group and control group under the same displacement conditions. Conclusion DSCM scaffold combined with SDSCs can be successfully built into tissue engineering nucleus pulposus in vitro.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.