Not checkedNot checked for notices yet.
Effect of Processing Parameters on Hot Deformation Behaviour and Microstructural Evolution of PM Ti-5553 Alloy at a Moderate-high Strain Rate
Qinyang Zhao, Fei Yang, Rob Torrens and 1 more
Materials Research · 2019
doi:10.1590/1980-5373-mr-2018-0738 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Isothermal compression tests of Ti-5553 (Ti-5Al-5V-5Mo-3Cr) alloy, produced by a fast consolidation approach from blended elemental powder mixture, were performed on a Gleeble® 3800 thermal-physical simulator to investigate its hot deformation behaviour. The samples were compressed in a wide temperature range from 700 ºC to 1150 ºC and a moderate-high strain rate of 1 s-1, with the sample deformation degree of 30%, 50% and 70%, respectively. Flow instability occurred when the deformation temperature was less than 900 ºC. Dynamic recovery (DRV) accompanied by dynamic recrystallization (DRX) become the dominated mechanisms at the medium temperature range between 900 ºC and 1000 ºC, while almost only DRV features could be observed at high temperature (1050 ºC ~ 1150 ºC). Moreover, α phase globalization could be identified in the alloy deformed in (α+β) region. DRV, DRX, α globalization and the transformation of α to β phase were promoted with the increasing deformation degree.
Abstract licence: CC BY
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.