Thermal and fluid flow characteristics in a tube equipped with peripherally-cut dual twisted tapes
Changcharoen W., Somravysin P., Eiamsa-ard S.
Open Engineering · 2014
doi:10.1515/eng-2015-0009 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
This article presents an experimental analysis of the turbulent flow of water in a heat exchanger tube fitted with peripherally-cut dual twisted tapes (PDTs) under a constant wall heat-flux condition. The peripherallycut dual twisted tapes with different cutting pitch ratios (l/y = 0.5, 0.75 and 1.0) were tested for Reynolds numbers in the range of 5400 to 14,000. The experimental results showed thatNusselt number and friction factor of the tubes fitted with PDTswere considerably higher than those of the plain tube and those of the tubes with single twisted tape (ST) and dual twisted tapes (DTs). It was found that PDTs with l/y = 0.5, 0.75 and 1.0 gave higher heat transfer rate than the typical DTs, with average Nusselt numbers greater by 12.1%, 7.8% and 3.8%, respectively. For the range investigated, PDTs with the smallest l/y ratio offered the highest thermal performance factor of 1.14.
Abstract licence: CC BY
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.