Skip to content
naulon
Not checkedNot checked for notices yet.

Analysis Of Drilling Of A Metal Plate With Pilot Hole

Kim K.S.

Archives of Metallurgy and Materials · 2015

doi:10.1515/amm-2015-0119 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

This paper performed a numerical analysis study of the cutting characteristics when drilling a taper hole whose upper and lower diameters are different, that is, a pilot hole. 3-dimensional drilling analysis was performed using a commercial code, and these results were used to determine analytically and compare the cutting temperature, the phenomenon of cutting chip formation, deformation and pressure, etc., for the tools, chips, and specimens during cutting. Also, cutting force and the required energy were calculated and compared. To verify the results of analysis, a cutting dynamometer was used to analyze 3-axis cutting force. Results of analysis showed that the specimen maintained a temperature of approximately 650°, with rapid cooling after chips were formed from the specimen. The tool reached a maximum of 700°, similarly to the chips. It is expected that these results will be utilized to optimize cutting processes and work conditions when drilling holes.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.