Not checkedNot checked for notices yet.
Feedback control of temperature in the pyrolysis process by using microwave heating system
Yutthapong Pianroj, Saysunee Jumrat, Seppo Karrila and 2 more
Songklanakarin Journal of Science and Technology (SJST) · 2021
doi:10.14456/sjst-psu.2021.207 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Microwave (MW) heating has gained popularity because it can provide rapid and more uniform heating than conventional methods. As the pyrolysis mechanisms and products strongly depend on temperature, aside from uniformity of temperature also control of its level will strongly affect experimental results. A temperature control system was developed for use in an experimental MW cavity in which a metallic propeller driven at 50 rpm is used to scatter the MW radiation. The results show good performance of the developed feedback control system. It was experimentally tested with water at temperature setpoint 80 ℃; and with a pyrolysis substance (oil palm shell biomass or OPS, mixed with activated carbon or AC) at set-points 400, 500, and 600 ℃. The largest bio-oil yield was obtained at the experimental conditions: ratio 70:30 at 500 °C; and the dominant chemical components found were phenol and acetic acid, as analyzed by GC-MS.
Abstract licence: CC BY-NC
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.