Correction of positioning and angular errors for ball screw feed unit
Yuuma TAMARU, Hiroki SHIMIZU, Hiroshi KAMODA
Nihon Kikai Gakkai ronbunshu · 2014
doi:10.1299/transjsme.2014dr0240 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
In the present study, we developed a new feed correction mechanism which corrected not only a positioning error (i.e., feed deviation) but also an angular error (i.e., yaw of a table). A correction mechanism including two piezoelectric actuators was constructed and installed between double nuts. The correction mechanism corrects positioning error if both piezoelectric actuators are expanded to the same length, and corrects angular error if one piezoelectric actuator is expanded and the other is contracted. First, the positioning and angular errors correction functions were investigated separately. A load was applied to one side of the table in order to simulate a counter force during machining. In the positioning error correction, a low-frequency component of positioning error was corrected effectively under the condition that the load for the table was set to at least 50 N. In the angular error correction, the correction capability was comparable to that of the positioning error correction up to the maximum load torque to the table, 1.4 Nm. The load torque was limited to 1.4 Nm because both piezoelectric actuators reached their saturation voltage. Finally, simultaneous correction of positioning error and angular error was examined, and the simultaneous correction capability was confirmed to be equivalent to the separate correction capabilities.
Abstract licence: CC BY-NC-ND
References10
10 more references, whose wording the paper’s licence keeps private.
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.