Current-Distribution Measurement in Polymer Electrolyte Water Electrolysis Equipment and Polymer Electrolyte Fuel Cell Using NMR Sensor

In a polymer electrolyte fuel cell (PEFC), the current density through the polymer electrolyte membrane (PEM) is distributed along the electrode on the membrane electrode assembly (MEA). To increase the electric power density of a PEFC, it is necessary to locate local decreases in current density where electric power generation decreases due to a lack of hydrogen, flooding, and so on. Therefore, achieving a higher current density in a PEFC requires monitoring the local current density. We developed a new method to estimate the spatial distribution of current flowing through the MEA in a polymer electrolyte water electrolysis equipment (PEWEE) and a PEFC using Nuclear-Magnetic-Resonance (NMR) sensors. The magnetic field strength induced by current through the MEA in a PEWEE is acquired as the frequency shift of the NMR signal which is measured by the NMR sensor. The spatial distributions of the frequency shifts occurring along the MEA in a PEWEE and a PEFC was measured. In order to verify the method, the magnetic field strength induced by the current through the gas diffusion layer (GDL) in a PEWEE was analyzed theoretically under the assumption that the current through MEA was uniform. The frequency shift was then calculated as a function of the geometry of the GDL, current, and the position of the NMR sensor. From experimental and theoretical results, the frequency shift of the NMR signal is proportional to current density and depends on the position of the sensors. Using the measurement system, we also obtained the current distribution through the GDL in a PEFC generating electric power. In these studies, the experimental and theoretical results agree.

Abstract licence: CC BY-NC-ND

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.