Not checkedNot checked for notices yet.
Machinability analysis on helical milling of carbon fiber reinforced polymer
Haiyan WANG, Xuda QIN, Hao LI
Journal of Advanced Mechanical Design, Systems, and Manufacturing · 2015
doi:10.1299/jamdsm.2015jamdsm0057 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
In the helical milling process, a rotating tool traverses a helical trajectory to generate a hole. In order to investigate the cutting state in helical milling of carbon fiber reinforced polymer(CFRP), experiments were conducted with unidirectional and multidirectional laminates. Cutting forces, tool wear state and hole quality were discussed respectively. The effect of cutting parameters on the cutting forces was first presented, then the influence of different workpiece material on the cutting forces was secondly analyzed. Because of higher abrasion of carbon fiber, tool wear was a major problem without being ignored in the cutting process, so the study on the tool wear state was carried out from the point of wear process, wear form, coated state and change of element etc. Therefore the effect of tool wear on the cutting forces was detailedly analyzed. Next the relation between tool wear and entry delamination of hole-making was discussed. Finally, inner delamination, delamination factor, diameter error, surface roughness and circularity error were also investigated in detail.
Abstract licence: CC BY-NC-ND
References13
13 more references, whose wording the paper’s licence keeps private.
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.