Skip to content
naulon

Not checkedNot checked for notices yet.

Effect of pre-bending deformation on mechanical properties of complex phase steel CP800

SUN Hao-fei, XIAO Zhi, WEI Kai and 2 more

Cailiao gongcheng · 2021

doi:10.11868/j.issn.1001-4381.2020.001012 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The pre-bending specimens were obtained by stamping with complex phase steel CP800, and the effect of pre-bending deformation on microstructure, residual stress and mechanical properties of the steel were studied by using EBSD, X-ray residual stress measurement system, tensile testing machine,DIC technique, <i>etc</i>. The results show that the distribution of residual stress of pre-bending specimens exhibits stress distribution of tension-compression-tension-compression, which means that the inside surface (compression layer) is tension stress and outside surface (tension layer) is compression stress. Such special distribution leads to a 16% reduction of yield stress of specimens after pre-bending. Meanwhile, due to the dislocation strengthening and hardening caused by cold deformation, the elongation of material decreases by 25% and the tensile strength increases by 24% after pre-bending. Furthermore, it is found that the inside surface produces greater plastic strain and is broken earlier than the outside surface due to the existence of tensile residual stress.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.