Skip to content
naulon

Not checkedNot checked for notices yet.

Friction and wear property of CNT-SiC hybrid reinforced aluminum matrix composites prepared by powder metallurgy

ZHANG Jun, LIU Chong-yu

Cailiao gongcheng · 2020

doi:10.11868/j.issn.1001-4381.2019.000333 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Silicon carbide (SiC) particles,carbon nanotubes (CNT), SiC and CNT hybrid reinforced 7055Al composites were prepared by powder metallurgy with 7055Al as matrix. The dry sliding friction and wear behavior of the three composites were studied. The results show that the wear mass loss increases and the friction coefficient decreases slightly with the increase of the load.The wear mass loss of the SiC-CNT/7055Al composite is lower than that of the single SiC/7055Al and CNT/7055Al reinforced composites at 0.5 MPa and 1.0 MPa.The wear mass loss of the SiC-CNT/7055Al composite increases rapidly at 2.0 MPa. With the increase of the load,the wear resistance of CNT/7055Al composite increases gradually;under medium and high load,the composite owns better wear resistance.The wear amount of SiC/7055Al composite increases gradually with the increase of the load, and the wear mass loss increases little at load of 2.0 MPa.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.