Skip to content
naulon

Not checkedNot checked for notices yet.

Effect of scanning path on thermo-mechanical field of laser solid forming TC4 part

LU Xu-fei, LIN Xin, MA Liang and 2 more

Cailiao gongcheng · 2019

doi:10.11868/j.issn.1001-4381.2018.001474 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

In order to mitigate both residual stress and distortion induced by large thermal gradient in laser solid forming (LSF) process, the <i>in-situ</i> measurement first was used to monitor the thermal and distortion evolutions of the substrate during LSF and to calibrate the finite element model. Using the validated model, the effect of different scanning paths on the evolution of thermo-mechanical fields in LSF was analysed. The results show that good agreement is obtained between the numerical results and the experimental measurements. The maximum thermal gradient and the maximum tensile stress occur in the deposition of the first layer, and with the increasing of the layers, the temperature gradient is reduced gradually. The largest distortion is resulted from the long edge unidirectional scanning mode while the minimum residual stress and distortion is produced by short edge reciprocating scanning. The checkerboard scanning method can effectively reduce distortion of the substrate while hardly reduce the residual stress. In addition, the transverse bending of the substrate can notably curb the longitudinal bending of the substrate. Stress relaxation induced by the phase transformation has a significant effect on both residual stress and distortion of LSF part.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.