Skip to content
naulon

Not checkedNot checked for notices yet.

Microstructure and Abrasion Resistance of In-situ TiC Particles Reinforced Ni-based Composite Coatings by Laser Cladding

MA Shi-bang, XIA Zhen-wei, XU Yang and 3 more

Cailiao gongcheng · 2017

doi:10.11868/j.issn.1001-4381.2016.001215 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Laser cladding of Ni-based Ni60A+<i>x</i>% (SiC+Ti)(mass fraction,the same below) composite powder coating on 45 steel substrate was studied by using the method of preplaced powder. The dry friction and wear experiments of different material coatings were carried out by reciprocating friction wear tester. The microstructure and worn morphology of cladding layers were observed and analyzed by using metallographic microscope, scanning electron microscope(SEM) respectively. The results show that the prepared composite coating with dispersively distributed TiC enhanced particles are obtained <i>in-situ</i>, the size and number of the granular TiC gradually increase with the increase of the composite powder SiC+Ti. When the composite powder SiC+Ti reaches 60%, pores and inclusions defects exist in microstructure. When the composite powder SiC+Ti reaches 48%, wear resistance of cladding coating is the best. The wear behavior of the composite coating is abrasive wear, and the mechanism is micro cutting and extrusion spalling.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.