Skip to content
naulon
Not checkedNot checked for notices yet.

Design and analysis of a 2-degree-of-freedom flexure-based micro-motion stage

Yunsong Du, Tiemin Li, Yao Jiang and 1 more

Advances in Mechanical Engineering · 2016

doi:10.1177/1687814016638301 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

This article presents the mechanical design, dimensional optimization, finite element analysis, and experimentation of a 2-degree-of-freedom flexure-based micro-motion stage. The stage is composed of four parallel limbs with symmetrical configuration, and each limb is composed of two serially connected prismatic joints. The divided parts of flexure hinge thickness constituting the two prismatic joints are selected as two. Based on analytical models established in stiffness and dynamic analysis, the dimensional optimization is carried out to maximize the first resonance frequency. Finite element analysis is then adapted to verify the stiffness, workspace, and dynamic behavior. Finally, a prototype of the stage is manufactured and an experimental platform is set up. The experimental results show that the stage has a workspace range of 19.53 µm × 19.07 µm with a frequency of 1987 Hz, and the cross-coupling ratio between two axes is less than 1%. For high-frequency cooperative tracking experiments, a proportional–integral controller is implemented to compensate for the tracking errors. Finally, good tracking performance at high frequency is obtained, which validates the effectiveness of the micro-motion stage.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.