Skip to content
naulon
Not checkedNot checked for notices yet.

Hydraulic Gap Control on Strip Rolling Mills

C. D. Collinson

Measurement + Control · 1971

doi:10.1177/002029407100400302 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Early applications of hydraulic loading were confined to foil rolling mills but recent developments have been rapid. Prestressed mills were adopted to obtain high stiffness and stability. The addition of modern quickly-responding electro-hydraulic equipment and accurate transducers has given these mills even higher effective stiffness and resulted in very good gauge control. The proving of hydraulic load and position controls in service on these mills has enabled them to be applied with confidence to ‘pure’ (screwless) hydraulic mills which are less costly than conventional mills and give improved performance. They are being widely adopted. Control methods, the requirements for transducers, hydraulic systems, etc., and the essential functions of a hydraulic gauge control are described herein.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.