Skip to content
naulon
Not checkedNot checked for notices yet.

An edge identification method for gap in-line measurement based on fillet assumption

Qijian Zhao, Pengfei Sun, Yu Cao and 1 more

Measurement + Control · 2022

doi:10.1177/00202940221117272 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The optical measurement technology could reduce manual work and improve quality in assembly. The confocal scanning scheme is proposed to measure the narrow gap in-line but it is hard to identify the edges of a gap. This paper proposed an edge definition and presented an edge identification method for gap measurement. The edge profile is defined as a part of a circle, which could be identified by the shutter time feature. The defined edge point could be calculated by fitting the edge profile, and then the width of a gap section is calculated by two edge points. The width of a gap can be evaluated by the average of several gap section. The experimental results indicate that the repeatability of the method is less than 2 µm and the precision of the measurement is higher than ±2.5 µm. The proposed method is feasible for in-line measurement application in assembly.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.