Skip to content
naulon

Not checkedNot checked for notices yet.

High Temperature Measurement Up to 1100 <formula formulatype="inline"><tex Notation="TeX">$^{\circ} \hbox{C}$</tex></formula> Using a Polarization-Maintaining Photonic Crystal Fiber

Qiangzhou Rong, Xueguang Qiao, Tuan Guo and 7 more

IEEE Photonics Journal · 2014

doi:10.1109/jphot.2014.2300474 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

A reflective fiber-optic interferometer for ultra-high temperature measurement is proposed and experimentally demonstrated. The device consists of a short piece of polarization-maintaining photonic crystal fiber (PM-PCF) spliced with a lead-in single mode fiber (SMF) without any offset. The hollow holes within the PM-PCF are partly collapsed due to the directional arc-heating splicing and excite two linearly polarized (LP) modes over the downstream PM-PCF. These two LP-modes are reflected at the end face of PM-PCF and backward recoupled into the lead-in SMF through the collapsed region. A superimposed interference pattern is obtained as the result of interference of the polarized modes. The proposed interferometer is demonstrated for ultra-high temperature measurement up to 1100 &#x00B0;C with a sensitivity of 12.3 pm/&#x00B0;C over repeated measurements. Meanwhile, isochronally thermal annealing has been studied to address the effect of residual stress in the sensing probe and the feasibility of further improving temperature measurement range of the device.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.