Skip to content
naulon
Not checkedNot checked for notices yet.

Characterization of Turn-On Time Delay in a Fiber Grating Fabry–Perot Lasers

H. K. Hisham, G. A. Mahdiraji, A. F. Abas and 2 more

IEEE Photonics Journal · 2012

doi:10.1109/jphot.2012.2214207 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

In this paper, turn-on time delay characteristics of a fiber grating Fabry-Perot (FGFP) laser are numerically investigated by considering all the carrier recombination rate (CRR) R(N) coefficients (nonradiative, A<sub>nr</sub>; radiative, B; and Auger coefficient, C). The results show that the turn-on time delay significantly reduces by increasing the injection current (I<sub>inj</sub>) and/or the initial value of carrier density (N<sub>i</sub>). Meanwhile, the turn-on time delay increases by increasing the CRR coefficients. However, its effect can be minimized by increasing I<sub>inj</sub> and/or N<sub>i</sub>. In addition, the turn-on time delay can be reduced by increasing the external optical feedback (OFB) level. Moreover, it is shown that the optimum external-cavity length (L<sub>ext</sub>) is 3.1 cm. Furthermore, an antireflection (AR) coating reflectivity value of 1 &#x00D7; 10<sup>-2</sup> is sufficient for the laser to operate at good turn-on time delay and low fabrication complexity. The obtained results can provide an important idea for the practical fabrication of the FGFP laser used in the dense wavelength-division multiplexing (DWDM) systems and optical access networks.

Abstract licence: CC BY-NC-ND

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.