Corrections to “3D Printed Elastomeric Lattices With Embedded Deformation Sensing”
Carolyn Carradero Santiago, Christiaan Randall-Posey, Andrei-Alexandru Popa and 4 more
IEEE Access · 2020
doi:10.1109/access.2020.2991896 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
In the above article <xref ref-type="bibr" rid="ref1">[1]</xref>, Figure 3 should read “Isometric view of two wires forming a capacitor in the measured configuration. The yellow wire is the top plate and the red is the bottom plate of a capacitor. The gray is a dielectric elastomer lattice, the deformation of which can be indirectly determined by measuring the capacitance.” Figure 4 should read “Isometric (A) and bottom view (B) of a lattice with an alternative configuration in four quadrants for selective sensing. The selectivity can be extended to any combination of cells in both vertical and horizontal configurations.” In <xref ref-type="fig" rid="fig9">Figure 9</xref>, the <inline-formula> <tex-math notation="LaTeX">${x}$ </tex-math></inline-formula>-axis should read “Min Deformation Slow; Min Deformation Fast; Max Deformation Slow; Max Deformation Fast.” A sentence in the introduction should read “Within the context of additive manufacturing, lattices are the focus of significant research since they...” The authors requested this correction for clarity purposes.
Abstract licence: CC BY-NC-ND
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.