Skip to content
naulon

Not checkedNot checked for notices yet.

Influence of calcined halloysite on technological & mechanical properties of wall tile body

N. Tamsu Selli, I. M. Aker, N. Basaran and 1 more

Journal of Asian Ceramic Societies · 2021

doi:10.1080/21870764.2021.1974762 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The effect of adding 0.1, 0.3, 0.6, 1.0 wt.% halloysite clay, which calcined at 600, 800, 1000 and 1200°C, to the standard wall tile slurry was studied. Wet milled halloysite was sieved with different sizes to examine the halloysite grain size effect. The granulated samples were pressed by applying a pressure of 30 MPa using a hydraulic press and made ready for sintering at 1150°C for 30 minutes. Detailed technological, mechanical and microstructural characterization studies were done on sintered samples. Compared to standard wall tile, almost all the halloysite added samples displayed similar technological properties but higher green and fired strength values. The produced sample with adding 0.6% halloysite (at 600°C calcined) by weight showed a higher firing strength with 28.75 MPa value than the minimum requirement (17.75 MPa). Observation of needlelike microstructure in the porcelain body led to establishing a simple relationship between the interlocking effects of thin needlelike mullite grains and increasing strength values. This study has shown that the addition of calcined halloysite may be an alternative to produce a thinner section wall tile product.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.