Skip to content
naulon
Not checkedNot checked for notices yet.

Automatic compensation of tool disturbances, caused by an unstable cutting process

Gusev Vladimir

MATEC Web of Conferences · 2019

doi:10.1051/matecconf/201929800017 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Modern machining processes are characterized by a separate functioning of the elements of technological system (TS). The cutting mode, that determines the machining efficiency, depends on the functional capability of a low-performance element, and the other higher-performance elements are not able to reduce the workload of the first element. The “strong” element of the TS can not help the “weak” one in reducing the received workload. The transfer of a part of the workload from the “weak” to the “strong” element allows to use the higher cutting mode. In such statement the increase of efficiency of machining processes in the scientific and technical literature was not observed. Is offered to connect a pliable cutting tool with a rigid large-sized workpiece by special contact knot, which allows to compensate the tool perturbations, caused by unstable process of cutting. This knot provides a dissipative and elastic connection between the tool and the workpiece, has been made and tested at holes machining. As a result the increase of efficiency of machining processes of holes was installed.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.