Skip to content
naulon
Not checkedNot checked for notices yet.

Continuous prefabricated cross-beams manufactured by using off-shuttering molding technologies

Prokopovich Anatoliy, Repekto Vladimir, Aleshin Andrey

MATEC Web of Conferences · 2018

doi:10.1051/matecconf/201819602021 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The paper describes a new constructive solution of prefabricated cross-beams manufactured be using off-shuttering molding technologies. Prefabricated elements of such cross-beams are pre-stressed trough-shaped parts. Together with hollow slab panels, stacked on the upper surfaces of their vertical walls, they serve as permanent shuttering for installing required crosswise and longitudinal (for support moments) reinforcement and for further pouring of cast concrete. The study provides a methodology and gives tests results of three series of prototype samples and of one full-sized prefabricated cross-beam. The purpose of the tests is to study the actual work of prefabricated cross-beams of the proposed construction. To analyze the test results, the authors performed check calculations of prototype samples according to the existing Russian design regulations of reinforced concrete structures. The obtained data analysis leads to a conclusion that the proposed construction of prefabricated cross-beams is quite reliable and makes it possible to give recommendations on their calculation and design.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.