Skip to content
naulon
Not checkedNot checked for notices yet.

Optimization of WEDM process during machining of Al-Al2O3 composite using Taguchi based Grey Relational Analysis

Mohan Singla Aaryan, Sharma Shubhang, Kaul Akshay and 1 more

MATEC Web of Conferences · 2018

doi:10.1051/matecconf/201817204008 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Aluminium ceramic (Al-Al2O3) is used comprehensively all over the world. In this paper, input parameters on Al-Al2O3 workpiece are applied to investigate the MRR and surface roughness by the process of wire electrical machining (WEDM).Four varying input parameters (Ton, Toff, Wf and Cs%) were tabulated for nine samples using L9 orthogonal array design technique whereas keeping wire tension as constant. Tool wear is calculated as the change in initial thickness and final thickness after cutting operation using screw gauge. The surface roughness is found using surface roughness tester.Minitab is used to plot the graph between input parameters against various output parameters. To find the impact of process parameters, ANOVA (Analysis of Variance) is used.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.