Skip to content
naulon
Not checkedNot checked for notices yet.

Selection of cutting parameters for the machinability of Inconel 718 using Grey Relational Analysis

Sunit Rout Ivan, Pal Pandian P.

MATEC Web of Conferences · 2018

doi:10.1051/matecconf/201817204004 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Inconel 718 is considered to be most difficult to machine superalloy because of its high shear strength, work hardening and precipitation hardening. Abrasive particles which are in microstructure have tendency have forming chip to be welded to tool and form built up edge (BUE) making it more difficult to machine. Friction between tool and material and its low thermal conductivity results in high temperature generation. Certain tools such as Ceramics are present which machine this material at prime cutting conditions. This paper addresses the cutting parameters needed most for providing low surface roughness

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.