Skip to content
naulon
Not checkedNot checked for notices yet.

Adaptive robotic end-effector with embedded 3D-printed sensing Circuits

Zapciu Aurelian, Constantin George, Popescu Diana

MATEC Web of Conferences · 2017

doi:10.1051/matecconf/201712108008 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

The paper presents the development and testing of an adaptive robotic end-effector used for manipulation of sensitive objects such as fruits and vegetables. The end-effector uses Fin-Ray-structured 3D-printed fingers with embedded conductive 3D-printed sensing circuits, which give the end-effector capacitive touch sensing and bend sensing capabilities. The conductive 3D-printed circuit is connected to a control circuit consisting of a low-current DC power source and a microcontroller. As the end-effector finger is subjected to various forces and other external stimuli, changes in the electric signals that run through the conductive circuit of the end-effector finger are detected by the microcontroller. The electric signal is processed in order to provide real-time information about contact detection, finger position or gripping force. This information was used for process monitoring purposes and as feedback for the end-effector actuator.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.