Skip to content
naulon
Not checkedNot checked for notices yet.

Ultrafine Sm-Fe-N Particles Prepared by Planetary Ball Milling

Neil D., Hadjipanayis G., Gabay A.

EPJ Web of Conferences · 2013

doi:10.1051/epjconf/20134006006 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Ultrafine magnetically hard particles are needed for the bottom­up fabrication of anisotropic exchanged­coupled permanent magnets. In this study we have chosen Sm2Fe17Nx because of its high anisotropy field and large saturation magnetization. A multi­stage planetary ball milling process was used. The key is to find the right balance of energy used to mill the precursor particles; it must be high enough to break the particles and reduce their size but, not so high as to destroy the crystal structure of the nanoparticles that would lead to deterioration of the magnetic properties. First the coarse powders were subjected to a wet milling with 2.0 mm diameter media. In each subsequent stage the media size was reduced to maintain the milling balance. Using such a process produced particles in a size range from 100 - 800 nm with a coercivity as high as 10 kOe at room temperature.

Abstract licence: CC BY

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.