Not checkedNot checked for notices yet.
Effect of Lap Joint Width to the Shear and Peel Stress Distribution of Bi-Adhesive
Hardi Witono, Hartono Rudi
E3S Web of Conferences · 2021
doi:10.1051/e3sconf/202132807015 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
A single lap joint is one of the most popular types of adhesive joints. This joint is very easy to apply and gives satisfactory results. However, there is an extensive shear stress distribution at both ends in a single lap joint and shallow in the middle. In this research, the performance test of the bi-adhesive with different joint widths was carried out. We modelled with 2D FEM consisting of adherent aluminum, two adhesives DP490 and ESP110 and then performed a static test to obtain shear and peel stress distribution. The results presented that using a bi-adhesive improved the shear stress distribution compared to a single adhesive individually. By adjusting the length ratio of each adhesive, the optimum conditions will be obtained. The peak stress will decrease, and the stress distribution will be better. In addition, the wider the lap joint, the stress distribution will be more evenly distributed. The peak stresses at the ends and in the middle of the joint are getting smaller in both the single adhesive individually and the bi-adhesive. This result is a recommendation for the user to increase the strength of the adhesive joint.
Abstract licence: CC BY
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.