Not checkedNot checked for notices yet.
Engineering geological characterisation of rock masses for design of excavation method and support system of Tanju Tunnel, West Nusa Tenggara, Indonesia
Dinata Edden Umaga, Indrawan I Gde Budi, Idrus Arifudin
E3S Web of Conferences · 2021
doi:10.1051/e3sconf/202132501004 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
This paper presents experiences with design and construction process of the Tanju Tunnel, West Nusa Tenggara. The objective of this research was to characterize the volcanic and intrusive rock masses for designs of the tunnel excavation method and support system. Engineering geological investigations were carried out, upon which the tunnel stand-up time was estimated and the tunnel excavation method and support system were determined based on the rock mass classifications of RMR (Bieniawski, 1989). The investigation results showed that the tunnel construction area consisted of colluvium, andesite, and tuff breccia. The rock masses were dominated by the andesite, which had UCS of intact rock ranging from 200 to 300 MPa classified as strong intact rock. Based on the RMR value, the andesite was classified as a good quality rock mass. The tunnel had unsupported roof stand-up time approximately 20.000 hours for a 3 m tunnel span. The recommended tunnel excavation method was full face, 1.0-1.5 m advance, and complete support 20 m from face, while the support systems were locally bolt in crown 3 m long and 2.5 m spacing, with occasional wire mesh, 50 mm thick shotcrete in crown where required.
Abstract licence: CC BY
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.