Taguchi Optimisation In Machining EN18 Using Coated Tool Under Dry and MQL Condition
Satynarayana Kosaraju, Swathi Are, Neeraja Kesari and 2 more
E3S Web of Conferences · 2020
doi:10.1051/e3sconf/202018401013 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Turning is one of the initial basic machining operation that prevails in assembly and production process. Modern techniques have been practices in rapid and eco-friendly production systems. Present study deals with the investigation of turning process on EN 18 steel which is been shown its existence in automobiles industries. Turning operation was performed using a coated tool insert with varying cutting speed (100, 125 and 150 mm/min), feed rate (0.05, 0.5, 0.15 mm/rev) and depth of cut (0.4, 0.8, 1.2 mm) at both dry and MQL conditions. The results obtained was compared to optimize the effect of minimum quality lubrication on surface roughness. Experimentally it was observed that speed of 100 m/min with combination of feed of 0.05 mm/rev and 0.4 mm depth of cut was found to be optimized for surface roughness in both the cases. The mathematical model generated for surface roughness and MRR for both dry and MQL turning models having better regression fit as it closer to 100. From ANOVA analysis feed was proved to be the highest contributing factor for surface roughness and for MRR speed is the most significant factor for both dry and MQL turning
Abstract licence: CC BY
References13
13 more references, whose wording the paper’s licence keeps private.
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.