Swelling of improved 16Cr–15Ni–2Mo–Mn–Ti–V–B steel under dose rates from 1×10−8 to 1.7×10−6 dpa/s

Radiation-induced swelling negatively affects the operability of structural units of fast breeder reactor (FBR) cores. Therefore, search for new and improvement of existing steels for reducing swelling is an important task. Since 2003, type 16Cr–15Ni–2Mo–Mn–Ti–V–B steel has shown a significant increase in radiation resistance due to its improved composition and heat treatment. Specialists of the JSC INM studied swelling of 16Cr–15Ni–2Mo–Mn–Ti–V–B steel with improved composition, data on the maximum swelling temperature, average swelling rate within typical coolant temperature ranges, as well as fast reactor dose rate were obtained. The obtained results are based on swelling measurements using hydrostatic weighing and transmission microscopy. Errors in hydrostatic measurements were examined with involvement of metallography data and selection of immersion liquid. It was revealed that the average swelling rate of improved 16Cr–15Ni–2Mo–Mn–Ti–V–B steel at the maximum swelling temperature is within the range of 0.04–0.14%/dpa. Shifting of this temperature from 460 to 520°C with increase of the maximum damaging dose from 60 to 80dpa (1.3× 10−6 and 1.7×10−6dpa/s, respectively), is observed. At doses below 10dpa and temperatures below 400°C the average swelling rate may reach 0.04%/dpa. At temperatures of about 600°C and irradiation doses below 50dpa the swelling rate does not exceed 0.01%/dpa during the whole period of observation.

Abstract licence: CC BY

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.