Skip to content
naulon
Not checkedNot checked for notices yet.

Wet etching of platinum (Pt) electrodes for piezoelectric transducers using a thick photoresist mask

Aziz Koyuncuoğlu, Dilek Işık Akçakaya, Özlem Şardan Sukas and 1 more

Micro and Nano Engineering · 2022

doi:10.1016/j.mne.2022.100153 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Platinum (Pt) is widely used in MEMS applications due to its inert nature and high temperature stability. In general, Pt is patterned using dry etching methods which require expensive machinery. In this study, we propose wet etching of Pt electrodes of piezoelectric transducers in hot Aqua Regia at 60 °C using a thick photoresist as a masking material. We showed that this method eliminates the need for metal hard mask and subsequent metal stripping, which may not be compatible with other structures on the process wafer. A stack of Si/Ti/Pt was used as a test sample to verify the effectiveness and chemical stability of AZ® 9260 and SPR™ 220-7 type photoresists in hot Aqua Regia. The optimized process was then successfully applied on a wafer with a pre-patterned pulsed laser deposited lead zirconate titanate (PLD-PZT) using SPR™ 220-7 photoresist. The suitability of the etching process was verified using optical imaging and SEM-EDS analysis. An etch resolution of 3.5 μm was achieved for 100 nm thick Pt thin films after 15 min immersion in hot Aqua Regia at 60 °C without any plasma cleaning. Using descum process with Ar plasma beforehand decreased the etching time down to 3:45 min and improved the minimum feature size down to 1 μm.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.