Not checkedNot checked for notices yet.
Microsecond measurement resolution for process cycle diagnostics of micro-EDM milling
Zsolt János Viharos, Balázs Zsolt Farkas
Measurement: Sensors · 2021
doi:10.1016/j.measen.2021.100123 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Ceramics are non-conductive materials, consequently, they cannot be machined directly by any electrical means. If these ceramics contain some small fractions of conductive components, e.g., as pollutant or as glue materials, they perform a certain, really low level, local and accidental flash of some conductivity. The reported research was performed on this border of science, with ceramics that are below the practical and also below the state-of-the-art conductivity level for electrical machining. Even so, micro-Electric Discharge Machining (micro-EDM) for cermaics was developed with varying and many times uncertain success. The paper describes the required, extended measuring system of a micro discharge milling machine equipped with a linear encoder, voltage, and current sensors. With the help of the installed measuring system, the ceramic discharge milling of the Al2O3–TiC mixture was tested, in particular, the process stability, the geometric transient zones and the edges of the machined grooves.
Abstract licence: CC BY-NC-ND
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.