Skip to content
naulon
Not checkedNot checked for notices yet.

Micro-addition of Fe in highly alloyed Cu-Ti alloys to improve both formability and strength

B. Rouxel, Cyril Cayron, Julien Bornand and 2 more

Materials & Design · 2022

doi:10.1016/j.matdes.2021.110340 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Cu-Be alloys provide excellent electrical and mechanical properties, but present serious health hazards during manufacturing. Among alternative alloys, the Cu-Ti system has the highest yield strength; however, Ti cannot be easily solutionized at concentrations above 4 wt%, resulting in a relatively low formability. In this study, Cu-xTi-yFe (x = 3, 5, 6 wt% and y = 0, 0.3 wt%) alloys were studied after both solution-annealing and age-hardening through mechanical testing and microstructure analysis. Micro-additions of Fe kept high concentration of Ti in solid solution (up to 6 wt%) after water quenching and suppressed the classical “wave-like” early-stage precipitation. Instead, a new dispersion of nano precipitates was observed. This behavior results in doubling the ductility in the solution annealed state (up to 48% elongation), together with maintaining a very high strength after ageing (up to 975 MPa) from precipitation of metastable nano α-Cu4Ti. This study shows that Fe micro-additions, when combined with a higher amounts of Ti (6 wt%), enables the production of Cu-based alloys combining high formability and strength, providing an excellent alternative to Cu-Be in mechanical applications.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.