Skip to content
naulon

Not checkedNot checked for notices yet.

Ultrasonic-assisted soldering of Mg alloy joints using Cu-foam/Sn composite solder foils

Shiqin Li, Yinggan Zhang, Huijun Cao and 3 more

Journal of Advanced Joining Processes · 2022

doi:10.1016/j.jajp.2021.100092 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

Mg alloys have been increasingly utilized in our daily life due to the low density and high specific strength and stiffness. However, the poor formability of these alloys restricted their adoption to some extent. The joining technique can effectively manufacture complex components, but some challenges are unique for Mg alloys. In this paper, reliable Mg alloy joints were realized by ultrasonically soldering at 250 °C for only 5 s. By using Cu-foam/Sn composite solder foils, the average shear strength of Mg alloy joints rose to 53.06 MPa, a 44.4% increase compared without using composite solder. The strengthening mechanism was attributed to the unique structure of 3D continuous Cu skeletons and the formation of high-hardness MgSnCu grains wrapped on skeletons after ultrasonically soldering, which could suppress crack propagation and block the excessive growth of Mg2Sn grains. The theoretical calculation confirmed that the formation energy of MgSnCu phase was lower than that of Mg2Sn or Cu6Sn5 phase despite evidence that it not existed in the Mg−Sn−Cu equilibrium phase diagram. Our study could contribute to the development of ultrasonic soldering technology with composite solder and open an opportunity for further expanding the usage of Mg alloys.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.