Not checkedNot checked for notices yet.
Drilling and helical milling for hole making in multi-material carbon reinforced aluminum laminates
Gururaj Bolar, Advith K. Sridhar, Aashrayi Ranjan
International Journal of Lightweight Materials and Manufacture · 2022
doi:10.1016/j.ijlmm.2021.11.004 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
Dissimilar properties of the constituent materials in Fiber Metal Laminates (FMLs) make hole making a demanding task. Improper selection of the process and the process parameters can result in poor surface quality, dimensional inaccuracy, or even failure of the component. The work, therefore, compares the drilling and helical milling process for hole-making in carbon fiber aluminum laminates (CARALL). The comparison was carried out by evaluating the machining forces, chip morphology, machining temperature, surface roughness, hole size, and burr size. The experimental results revealed significantly lower machining forces and machining temperature during helical milling. Utilization of helical milling for hole making resulted in the production of holes within H9 diameter tolerance. Substantial reduction in the surface roughness was noted during helical milling by virtue of the discontinuous chips generated during the process. Furthermore, holes processed using helical milling showed relatively smaller-sized burrs in comparison to the drilling process. Overall, the initial evaluation exhibits the positive capability of helical milling for hole-making in CARALL FMLs.
Abstract licence: CC BY-NC-ND
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.