An indirect heating solution to reduce CO2 emission and improve efficiency of gas distribution networks
Stefan Romocki, Jamshid Zarkesh, Henry Melloy and 2 more
Energy Reports · 2018
doi:10.1016/j.egyr.2017.12.003 (opens in a new tab)
We email you when a new notice or a question about this paper appears.
Abstract
The gas industry relies on indirect heating to prevent gas from freezing when it is transferred from high-pressure networks to lower pressure distribution systems. The main challenge in preheating natural gas is designing an indirect heating system capable of consistently maintaining a target temperature, despite large load diversity. The most common form of heating technology has traditionally been water bath heaters and boiler houses. In this paper, a novel technology is introduced, and its performance compared to existing installations. The Immersion Tube Thermosyphon Heater was developed specifically to address high load diversity; it combines a high-efficiency immersion burner with a sub-atmospheric two-phase loop thermosyphon. The use of low-temperature steam provides a flexible and precise solution for temperature control easily adapted to variable gas flows. The Immersion Tube Thermosyphon achieved an average thermal efficiency of 90%, considerably higher than the 46% efficient water bath, allowing an estimated annual saving of 7,660 tonnes CO2 for 1-megawatt gross heat capacity operating with a 50% load factor. Keywords: Gas preheating, Load diversity, Thermal efficiency, Water bath heaters, Two-phase loop thermosyphon, Temperature control, Transient load
Abstract licence: CC BY-NC
Reads
Read by people on this page
None yet.
Checked or read by AI through naulon
None yet.
A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.
Are you an author?
Is this your paper?
Claim it to add your note and be paid when agents cite it. Free.