Skip to content
naulon
Not checkedNot checked for notices yet.

Critical heat flux and Leidenfrost temperature on Electrical Discharge Machining (EDM) - constructed hemispherical surface

S. Illias, S. Hussain, N.A. Rosman and 4 more

Case Studies in Thermal Engineering · 2021

doi:10.1016/j.csite.2021.101312 (opens in a new tab)

We email you when a new notice or a question about this paper appears.

Abstract

This paper reports a Leidenfrost temperature on hemispherical surface constructed by Electrical discharge machining or known as EDM. We focus our study on the droplet evaporation lifetime to investigate and identify the Leidenfrost temperature. Three (3) different types of materials were selected i. e such as Brass (Br), Aluminum (Al) and Copper (Cu). Meanwhile, ethanol liquid has been chosen as the test liquid. Ethanol liquid was elected due to its low boiling point of approximately 78 °C. The droplet impact velocity and droplet diameter was approximately 1.129 m/s and 3.476 mm, respectively. As a result, we finally succeeded in determining the Leidenfrost temperature for all materials mentioned above. On top of that, all the Leidenfrost temperature results, TL were close to the superheat limit temperature of ethanol liquid, TSL which is about 197.8 °C.

Abstract licence: CC BY-NC

Reads

Read by people on this page

None yet.

Checked or read by AI through naulon

None yet.

A person counts once a day per paper. We keep no cookie and no address: a reader is a hash that changes every day. Any month under five reads shows no number.

Are you an author?

Is this your paper?

Claim it to add your note and be paid when agents cite it. Free.